Laser cleaning für Dummies

Therefore, for some problems, we have included related procedures into three levels of intensity, depending on the resulting effect of the procedure or the degree of invasiveness.

The benefits of laser cleaning Extremely gentle on the material While alternative methods to laser cleaning – such as sandblasting – can damage the surface of the component, the laser works rein a non-contact, residue-free manner.

As this cleaning method only uses a laser beam to vaporize the layer to Beryllium removed, there are literally no consumables with it. This is the beauty of lasers, which only need a power plug to be Reihe and ready to go.

A simple way to grasp the importance of the ablation threshold is to compare it to throwing a ball over a mauer. If you don't throw it high enough, it will never make it over to the other side.

cutting of aluminum sheet up to 8mm - travel approx. 1300 x 1300mm - machine control hinein german language

Let's continue with our analogy. Imagine there was a second, higher wall behind the first one and that a ball was thrown with just enough energy to make it over the first wall, but not enough to make it over the second.

The operation cost of a laser cleaning machine can be high when expensive maintenance or repairs are required! Lasers tend to be less robust and long-lived

The same metallographic sections were used to measure microhardness. The results confirmed a statistically significant dependence of the surface roughness with the position on the platform as well as with the recycling of the powder used. The corrosion resistance of the materials welches excellent. Increased porosity values and lower hardness occurred hinein the middle of the building platform. The reason for the variation of the properties within the building platform can be seen in the unequal laser input energy in the individual positions of the plate.

Contact-free laser cleaning is a superior alternative to many conventional cleaning technologies in industrial manufacturing and maintenance. Laser cleaning is non-abrasive to the surface, environmentally friendly and works at almost neglectable consumable cost.

The process flow enables the entire structure of the electrode (the top and bottom surfaces and all sidewalls) to be coated with a thin biocompatible layer before making the belastung photolithography process on the wafer, as illustrated in Fig. 5.18 :

Coating of the top side of the wafer with silicone rubber (all devices are entirely coated with silicone).

Hinein the case of the mixed-fluid spray cleaning, the PRE and incidence website of damage both increased as a function of increased gas flow Satz through the nozzle. Rein addition, with the commercial Organisation, the PRE was highest and consequently more damage events were observed at positions of the wafer where the spray from the nozzle had a higher incidence Satz, i.e. at wafer center and edge.

The inner sides of gas and oil pipelines can Beryllium affected by various kinds of depositions, which occasionally need to Beryllium removed. This is done with automated cleaning robots, which may apply different techniques, including laser cleaning.

To successfully remove a layer from a given material, the energy transferred by the laser beam must be above the ablation threshold of that particular material.

Leave a Reply

Your email address will not be published. Required fields are marked *